E16

  Product Name Price-
(image for) Input shaft ball bearing kit - LF

Input shaft ball bearing kit - LF

Ball bearing & oil seal for input shaft on Peerless 2318 transmissions used on all large frame front-mount Elec-Traks. These are the same made in...
$28.80

Add:

(image for) Drive Belt Set

Drive Belt Set

Matched set of two (2) oil, heat and abrasion resistant notched V-belts. Fits GE E15, E16, E20, I-series models, and Wheel Horse C-185 and B-145...
$28.00

Add:

(image for) Front wheel bearing set, large frame

Front wheel bearing set, large frame

Set of two front wheel bearings and one grease cap/cover. Includes heavy duty clip used on some front spindles. Fits all large frame models.
$25.00

Add:

(image for) Control Relay (Enclosed)

Control Relay (Enclosed)

DPDT relay with 36 volt coil and 3/16" terminals. Plastic case keeps the rodents out. Replaces original "Guardian" style - includes directions for...
$24.00

Add:

(image for) Key switch (plastic insert)

Key switch (plastic insert)

New old stock key switch. Metal with plastic insert, mounts in a 13/16" hole. Includes one key. Used in GE models E8, E10, E14, E15(HA-JA only), E16,...
$24.00

Add:

(image for) Motor brush set - dual shunt

Motor brush set - dual shunt

Brush set for permanent magnet drive motors and heavy duty large diameter mowing deck motors. Dual shunt leads, open flag terminal. Set of 2. Fits...
$24.00

Add:

(image for) Snow thrower auger chain (AD42)

Snow thrower auger chain (AD42)

Roller chain for 42" snow throwers, models AA, BA, CA. Includes master link. Part numbers 243A4714P31, 518332
$23.00

Add:

(image for) Hood Decal Set (E16)

Hood Decal Set (E16)

Vinyl decal set, laminated, white on brown, for left and right sides of hood. Mimics plastic signature plates used on E16 models.
$22.00

Add:

(image for) Mower motor brush set - large diameter

Mower motor brush set - large diameter

Brush set for large diameter mower motors. Set of 2. Fits front-mount mowing deck motors of all large-frame tractors with regular-duty 4.5" diameter...
$22.00

Add:

(image for) Snow thrower crank rod handle - AD42AA

Snow thrower crank rod handle - AD42AA

Crank rod handle for model AD42AA snow throwers. Part numbers 243A4714P78, 518379.
$22.00

Add:

(image for) Snow thrower motor sprocket (AD42)

Snow thrower motor sprocket (AD42)

Small sprocket for motor, 13-tooth. Fits 42" snow throwers, models AA, BA, and CA. Part numbers 243A4714P37, 518338.
$20.00

Add:

(image for) Brake/Clutch Switch

Brake/Clutch Switch

Brake switch, 2-7/8" spring-loaded actuator lever. Includes stainless steel mounting hardware. Fits B-145, C-185, E8*, E10*, EGT-80*, EGT-100*, E12,...
$19.80

Add:

(image for) Mower deck flap & hardware

Mower deck flap & hardware

Synthetic rubber flap for rear of mowing decks as used on all large-frame models. Includes stainless steel hardware for installation. Part numbers...
$18.80

Add:

(image for) Charger Capacitor - 20 mfd

Charger Capacitor - 20 mfd

Replacement 20 uf capacitor for early large frame models E12AA, E15AA, E15BA, and E16RA. Note that later versions used a smaller capacitor. As...
$17.80

Add:

(image for) Fuse for use with Alltrax Electronic Controller

Fuse for use with Alltrax Electronic Controller

Replacement fuse for use with Alltrax DCX300ET electronic controllers. 250 amp, protects against short circuits. Fits C-185, E12, E15, E16, E20,...
$17.80

Add:

All Content Copyright © 2007-2024
Free Range Electric, LLC
Waynesboro, VA 22980